Your Traxxas electronic speed control may require periodic calibration to maintain optimal performance. If your vehicle stops responding to throttle input, if you would like to change to a different mode, or if you switch from NiMH batteries to LiPo batteries you will need to go through these programming steps.
These programming steps are the same for the XL-2.5, XL-5, XL-10, EVX-2, VXL-3s, and VXL-3m.
Mine doesn't blink once it juste stay red
Awesome thanks for making it so simple
👍🏼👍🏼👍🏼👍🏼
The cars are great build quality and all but the electronics you guys put in these cars is beyond junk
Staying red after release no blinks
My xl5 turns red but won’t blink anyone know why
won't the RC take off if you full throttle it
This doesn’t work for me my remote only has steering trim
I did this but the light keeps fast flashing green. I have a TTX300 controller and I tried to set the throttle trim but I don't know when it's set correctly. Anyone have any ideas?
my latraxx only goes in reverse every 1 in 3 tries after going forwards. HELP
What if it don't blink
Dose the lipo need to be fully charged
Mine only blinks once and after I put full throttle ir doesn’t blink or do anything
I have an issue upon acceleration on my slash vxl 3s 2wd rc it stutters when given in throttle and times it accelerate on it own for a second. What could this be and can it be a bad esc?
If you have any problems with this procedure try to set your both trims to 0 and start again.
My esc doesn’t have a button on it how do I calibrate and set the throttle ?
My 4×4 slash would automatically drive. Did this, fixed it
Rustler vxl 4×4 had weak brakes until I did this!
Mine keeps blinking green when it said it should blink red once
the calibration isnt working. i go into full throttle and it never blinks red twice afterward
This doesn't work on mine. If I push and hold the ESC ON button it turns green then red. I release the button and wait for one red flash then pull full throttle on the transmitter (as described here). But then ESC LED goes out and stays out.
If I hold the ESC button when turning it on, it blinks red once, twice then three times and starts over. No response whatsoever.
I wrote to Traxxas about this a week ago and no response whatsoever.
How to calibrate front wheels properly
How long do I need to hold it? I’ve held the throttle open for 2 minutes. Nothing happened.
Thanks this worked
It works just fine up until it's supposed to flash green, never does and won't calibrate, no troubleshooting info anywhere either. Returned
This worked brilliantly when my Futaba Rx/Tx wasn't working with my Slash.
and yet i still have no throttle! UGHHHHH.
Does it works for nitro ? To